C Sort Flex-Flex Couplings
The C Variety coupling includes two flex hubs, one particular sleeve and one particular accessory kit consisting of seals and snap rings.
CFR Type Flex-Rigid Couplings
The CFR Style coupling consist of a single flex hub, a single rigid hub, one sleeve, one particular accessory kit consisting of seals and snap rings.
Options
Easy and reasonably priced style of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in place
Available as vertical and horizontal couplings
Broad variety of specific variations for example full-flex, flex-rigid mill motor
Standard configurations are available in the shelf
Ordering Information
Application: Driver and Driven.
Sort and size of coupling, horizontal, vertical and so on.
Electrical power: Motor horspower or torque requirement.
Velocity: Motor RPM or Driven RPM.
Distance between shaft ends (BSE).
Shaft sizes.
C and CFR Style Couplings
Ordering Info
Puller Holes are conventional on sizes 4 through 12.
Puller Holes are available for sizes 
7/8 via three.five at an additional charge.
The BSE (distance In between Shaft Ends) might differ concerning G and G1.
Interference bores without set screws are normal unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, consult Engineering Section.
Greater sizes can be found, please seek advice from Technical Support.
