Energy UNITS FOR LIFT TABLE 1
Basic Description
This electrical power unit is made exclusively for the little lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This electrical power unit has been broadly used while in the marketplace of logistic units including minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed by the solenoid valve together with the velocity controlled by the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Basic Description
This electrical power unit is designed exclusively to the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve as well as speed controlled by the adjustable needle valve. Once the lift rises to a large positoin, however the electrical power provide is lower, the reducing motion is controlled from the manual override perform.
Electrical power UNITS FOR LIFT TABLE three
Basic Description
This power unit is intended exclusively for that significant lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve as well as speed managed by a strain compensated movement manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Common Description
This electrical power unit is created solely for your massive lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve and the velocity controlled through the adjustable needle valve. When the lift rises to a higher positoin, but the power provide is lower, the decreasing movement is controlled from the guide override perform.
Unique Notes
1. This electrical power unit is of S3 duty cycle, which can only operate intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean the many hydraulic components concerned before installation of the power unit.
three. Viscosity with the oil shoud be 15~46 cst,which should really also be clean and free of charge of impurities.N46 hydraulic oil is encouraged.
four. Oil transforming is required after the original one hundred operation hrs,afterwards when each 3000 hrs.
five. The energy unit proven is designed to be mounted vertically.