SMR Gearbox Installation
Satisfactory functionality depends on right set up. lubrication and upkeep. therefore it is important the instructions within the set up and maintenance leaflet. provided with every single gearbox. are followed meticulously. several of the vital aspects of belt and torque-arm 
set up are listed beneath.
one. Install pulley on gearbox input shaft as close to your reducer achievable, and mount reducer on driven shaft as shut to bearing as practical. failure to perform this will likely bring about extra loads within the input shaft bearings and output bearings and could result in their premature failure.
2. Install motor and wedge belt drive using the belt pull at around 90° to the center line between driven and input shafts. this will allow tensioning of your wedge belt drive together with the torque arm which ought to preferably be in tension. if output hub runs anti-clockwise. torque arm ought to be positioned the appropriate.
3. lnstall torque-arm fulcrum on the rigid assistance so that the torque-arm will probably be at about correct angles towards the center line with the driven shaft plus the torque arm case bolt. ensure there is ample consider up during the turnbuckle for belt stress adjustment.
Preserve close.
Bell drive could be located in any handy postion. if your torque arm would be to be employed to tighten the belts, the drive ought to be at about tight angle on the line amongst the input and output shafts.
Bell drive may be situated to your suitable if wanted.
If output hub rotates clock-wise. place belt drive and torque arm in opposite direction to that proven during the illustration.
Torque arm and belt get up.
Torque arm may very well be mounted towards the correct if sought after.
