TF Style Flanges
Model TF flanges are created from the same high-strength cast iron because the S flanges, but are created to accommodate the international standard Taper Lock bushing for uncomplicated set up and removal
TF Kind flanges allow for mounting the bushing to the front (hub) side on the flange
TF flanges can be found in sizes six by 16 and might be applied with any style of sleeve as pictured on web page SF-5
TR Variety Flanges
TR flanges are very similar on the TF design, but enable for the Taper Lock Bushing for being mounted and removed from
the reverse or serration side of 
the flange
The constrained torque ratings on the Taper Lock Bushings make it possible for TR flanges to only be applied with EPDM or Neoprene sleeves
Diverse bushing sizes are made use of, so they have unique highest bores than the TF flanges
Sizes 6 as a result of 16 are available
Taper-Lock Bushings
The field regular taper lock bushing is usually a split style enabling a compression match with the flange on the shaft with no set screws
The very simple style and design tends to make the set up and removal simple whilst the 8° taper grips tight and gives great concentricity
A Diminished level of inventory could be attained on account of the many other energy transmission parts that use Taper Lock Bushings such as: sheaves, sprockets, and pulleys
will not offer you the Taper-Lock Bushings themselves as they are widely out there from other manufacturers
